True dual exhaust on your 3.8 Mustang. Deap throaty V-8 sound in addition to 15-20 HP gain.
Chris Casperson's Mom's 2000 V6 Mustang. What does your Mom drive?
Make sure to install your tailpipes first. A specific angle of the tailpipe is required to snake it over the axle as shown. Hang the tails with the factory hangers provided with the system.
Install flow tubes and mufflers next. DO NOT tighten until the system is complete.
Due to the location of the O2 sensor's threaded bung on this test X-pipe, the O2 sensor cables needed to be extended by about 6 inches. This will not be necessary with the production version.
Make sure the provided heat cover is fixed closest to the pipes for heat protection. In the production version of this X-pipe, the threaded bung for the O2 sensors are located closer to the transmission (X marks the spot). This eliminates the need to lengthen your O2 sensor cables.
Install The included heat covering over kick down linkage of transmission. Make sure there is a gap between the cat's heat shield and the linkage. Adjustments can be made when tightening the X-pipe.
Once the entire system is on place, tighten the bolts and clamps from front to back. Good Luck and have fun installing.
|
